Yamaha R6 slipper help

[headstart]

bigkaley;84490 wrote: http://www.motionpro.com/motorcycle/partno/08-0008/

Highly suggest this to hold the clutch basket instead of using the "bike in gear, stand on the rear brake and using an air impact gun" technique. At $32, it's much cheaper than a transmission rebuild. I have seen transmissions not hold up to the above technique for removing the clutch boss nut. Also, you'll never get a correct torque on the nut without it.

Yep, my bad on that. I totally had forgotten about the clutch holding tool- I have the motionpro tool and it makes it pretty painless to get the nut on and off and torqued back to spec.

 

[Burnall4]

lemondrop;84624 wrote: HA! after your brake bleeding abilities were tested at the beginning of this season...i might try it on my own

LOL it wasn't my fault the POS craftsman speed bleeder I bought was broken, you didn't complain when I sat there with you for an hour doing it the old fashion way

 

[lemondrop]

I felt bad for you since you had inadequate equipment

 

[barry38]

bigkaley;84534 wrote: It's just hard for me to leave my 2 day work week!

So that's 5 that I can use ya!