Marcmcm
New Member
Someone save me some time and buy this complete before I have to part it out. $3750
2002 Yamaha R6
Clean Title
31,978 Miles (chassis, engine miles roughly 16,000)
Traxxion Valved Forks setup for 175lb rider refreshed 2009-Spare springs
Ohlins Triple clicker-refreshed 2009-spare spring
Pro-Tek Rearsets-GP Shift
Cheetah Bodywork
520 Chain with Vortex sprockets
DynoJet Jet Kit
Yoshimura Full System
K&N Air Filter
NRC Case Covers-Both Sides-rashed
Clip-ons-Unknown Brand
Vortex Gas Cap
S/S Brake Lines
Vesrah Pads w/ 3 trackdays
Bridgestone BT-003s with 3 trackdays
Fully safety wired and has passed WERA tech
Has been down on the right side twice since I owned it. Hard to see in the pics but the tank has a dent in the right side and the subframe is NOT bent, the tail is just on a little crooked due to the exhaust hanger.
Spares Package
Engine-Complete but disassembled-Cracked Case
Complete engine case
Stock forks
Upper Triple
Lower Triple
New Barnett Clutch
Stock rear shock
Stock header
Micron High-Mount slip on
Passenger pegs
stock gas cap
kickstand
Fuel Sending unit
Rims with rotors -Polished but not very well
Front Rotors
Cush Drive with 48T Vortex sprocket and rubbers
ram air tubes
Most Engine Gaskets-New OEM
NRC Clutch cover-Rashed
Rear brake caliper w/ reservoir and master
2 coolant overflow tanks
choke cable
throttle cables
various clip-ons
2 fans
levers, frame sliders, and a bunch of fasteners and misc parts.
Bike is located just outside of State College, PA. Carbs were just completely disassembled, cleaned, tuned, and sync'ed 30 days ago. Can help with delivery as well. Picked up another R6 and this gal has to go. She has served me well for the past 3 years and runs well. Just did 3 days at NJMP with no issues!
Email me at Marc@pasportbikes.com
2002 Yamaha R6
Clean Title
31,978 Miles (chassis, engine miles roughly 16,000)
Traxxion Valved Forks setup for 175lb rider refreshed 2009-Spare springs
Ohlins Triple clicker-refreshed 2009-spare spring
Pro-Tek Rearsets-GP Shift
Cheetah Bodywork
520 Chain with Vortex sprockets
DynoJet Jet Kit
Yoshimura Full System
K&N Air Filter
NRC Case Covers-Both Sides-rashed
Clip-ons-Unknown Brand
Vortex Gas Cap
S/S Brake Lines
Vesrah Pads w/ 3 trackdays
Bridgestone BT-003s with 3 trackdays
Fully safety wired and has passed WERA tech
Has been down on the right side twice since I owned it. Hard to see in the pics but the tank has a dent in the right side and the subframe is NOT bent, the tail is just on a little crooked due to the exhaust hanger.
Spares Package
Engine-Complete but disassembled-Cracked Case
Complete engine case
Stock forks
Upper Triple
Lower Triple
New Barnett Clutch
Stock rear shock
Stock header
Micron High-Mount slip on
Passenger pegs
stock gas cap
kickstand
Fuel Sending unit
Rims with rotors -Polished but not very well
Front Rotors
Cush Drive with 48T Vortex sprocket and rubbers
ram air tubes
Most Engine Gaskets-New OEM
NRC Clutch cover-Rashed
Rear brake caliper w/ reservoir and master
2 coolant overflow tanks
choke cable
throttle cables
various clip-ons
2 fans
levers, frame sliders, and a bunch of fasteners and misc parts.
Bike is located just outside of State College, PA. Carbs were just completely disassembled, cleaned, tuned, and sync'ed 30 days ago. Can help with delivery as well. Picked up another R6 and this gal has to go. She has served me well for the past 3 years and runs well. Just did 3 days at NJMP with no issues!
Email me at Marc@pasportbikes.com
